Your kitchen is 4 square meters. You have one induction hob, a sink that doubles as a dish rack, and a landlord who will absolutely notice wort stains on the ceiling. Can you brew all-grain beer in there? Yes. I did it for eleven months in a 42 m² flat with a south-facing window and zero storage, and the only casualty was one hop bag that fused itself to the bottom of my stockpot.
What follows is the setup I wish someone had handed me at the start: a real equipment list, a realistic workflow, and the numbers I actually hit. No three-tier sculpture, no plate chiller, no garage. If you're searching for a simple all grain brewing setup for small spaces, this is the configuration that works — including the parts that frustrated me.
Key takeaways
- Brew-in-a-bag in a single vessel is the only all-grain method that genuinely fits a studio flat: one pot, one bag, no mash tun to store.
- Small batches of 8–10 litres are the sweet spot — you can boil them on a domestic induction hob and cool them in your own sink.
- Your real bottlenecks are ventilation, water volume and cleaning, not equipment cost.
- Budget around €250–350 for a complete, repeatable setup if you buy carefully.
- Propane is out. Induction or a stovetop gas ring with a window open is in.
Why single-vessel all-grain fits a small space
The standard advice for all-grain brewing assumes floor area. A mash tun, a hot liquor tank, a boil kettle, a fermenter, a chiller — that's five vessels, and each one needs somewhere to live between brew days. In a flat, storage is the constraint that kills the hobby, not the brewing itself.
Brew-in-a-bag collapses that entire chain. You heat water in one pot, add the crushed grain in a mesh bag, hold the temperature, lift the bag out, and boil in the same vessel. That's it.
What BIAB actually costs you
Efficiency. That's the honest trade. My first BIAB batches landed around 62–65% brewhouse efficiency, against the 72–75% a friend of mine gets with a proper mash tun and sparge. You compensate by using roughly 15% more grain, which for a 10-litre batch means maybe 300 grams extra — a couple of euros. I'll take that trade every single time in a small flat, and I'll argue about it with anyone who says BIAB is "not real all-grain."
The sink is your chiller
An immersion chiller needs to sit in the pot, which needs to sit in something. In my kitchen the pot goes in the sink with cold water and a couple of frozen water bottles rotating through it. Ten litres drops from boiling to pitching temperature in about 25 minutes in winter, closer to 40 in July. Slower than a plate chiller, but it costs nothing and stores in the sink it's already using.
The equipment list that actually fits
Here's what I ran, with prices from my own receipts. Everything nests inside the pot when not in use, which is the whole point.
| Item | Specification | Approx. cost | Storage footprint |
|---|---|---|---|
| Boil kettle | 20 L stainless stockpot with lid | €55 | One shelf |
| Mesh bag | Custom BIAB bag, fine mesh | €15 | Folds to nothing |
| Heat source | 2000 W portable induction plate | €60 | Drawer |
| Thermometer | Instant-read digital probe | €18 | Cutlery drawer |
| Fermenter | 11 L food-grade bucket with airlock | €22 | Corner of a cupboard |
| Bottling gear | Tap, wand, 24 swing-top bottles | €45 | Crate under the bed |
| Cleaning | PBW-style cleaner, no-rinse sanitiser, spray bottle | €25 | Under the sink |
Total: around €240. Add a grain mill if you want to buy base malt in bulk (I didn't — the homebrew shop crushed it for free) and you're still well under €350.
What I bought and regretted
A 30-litre pot. Sounds sensible, right? It didn't fit under my extractor hood, so I had to boil it half off the hob, which meant uneven heat and a scorched patch on the base. I sold it at a loss after two batches and went back to the 20-litre. Measure your hob and your extractor clearance before you buy anything. That's the single most useful piece of advice in this article and nobody gives it.
I also bought a glass carboy. Beautiful. Terrifying to carry full up a narrow staircase. It now holds spare change.
The workflow, minute by minute
A 10-litre batch takes me about four and a half hours from tap-on to everything-washed. Here's how it runs.
- Heat 16 litres of water. That's strike water plus a margin for grain absorption and boil-off. On 2000 W it takes roughly 35 minutes.
- Mash in at 66°C. Grain goes into the bag, bag goes into the pot, lid on. Wrap the pot in a duvet or a sleeping bag — that's your insulation, and it held my temperature within 2°C over 60 minutes.
- Lift and drain the bag. Hang it over the pot from a cabinet handle with a bit of cord. Squeeze with clean hands. This is where you get your efficiency back.
- Boil for 60 minutes. Hop additions at 60, 15 and flameout. This is your one ventilation-critical window.
- Chill in the sink, then transfer to the fermenter through a sieve.
- Pitch yeast, seal, airlock. Ferment somewhere dark at a stable temperature — mine sat in a wardrobe at a steady 19°C.
Ventilation is not optional
A 60-minute boil in a small kitchen puts a lot of moisture into the air. In my first month I didn't run the extractor fan properly and ended up with condensation running down the window and a faintly beery smell in the hallway for days. Now: extractor on full, window cracked, kitchen door closed. If your flat has no extractor hood, brew near an open window and accept that winter brewing is a colder, draftier affair.
Water in, water out
Nobody warns you about this. A 10-litre batch uses roughly 25–30 litres of water once you count strike water, cleaning and sanitising. In a flat with one sink, you'll be filling and draining in stages. I used two 10-litre buckets to shuttle water and clean as I went, rather than letting everything pile up in the sink at the end. Cleaning a pot the moment it's cool takes four minutes. Cleaning it the next morning takes twenty.
Comparing the realistic options
BIAB isn't the only route, and if you have a bit more room — a utility corner, a large balcony — a compact all-in-one electric system might suit you better.
| Approach | Space needed | Cost | Efficiency | Best for |
|---|---|---|---|---|
| BIAB, single pot | One shelf + hob | Low | 62–68% | Flats, studios, shared kitchens |
| Compact all-in-one electric | One dedicated surface | Medium–high | 70–75% | Utility corner, small spare room |
| Cooler mash tun + kettle | Two vessels stored | Medium | 72–76% | House with storage, larger batches |
| Extract brewing | One pot | Low | n/a | Anyone who wants shorter brew days |
The all-in-one machines are genuinely good. A friend brews on one in a 6 m² utility room and swears by it. But they're a single-purpose appliance that occupies a permanent surface, and in a flat every permanent surface is already spoken for. My verdict: BIAB for the first year, upgrade only if you move somewhere with a utility room.
The things that went wrong
My third batch was a saison that fermented at 26°C because I put the bucket next to a radiator in October. It tasted of bananas and solvent. I drank it anyway, out of stubbornness, and learned more from that batch than from the three that went well.
Batch six: I miscalculated boil-off in a new pot and ended up with 7 litres instead of 10, at an original gravity about 12 points higher than intended. It became a decent strong ale. Accidental, but decent.
And the ceiling. I mentioned the ceiling. Lifting a bag of hot, wet grain out of a 20-litre pot is heavier than it looks, and if the bag tears above a full boil, you will be cleaning wort off a surface you cannot reach. Buy a bag with reinforced seams, and lift slowly.
What about the cheapest possible route?
If you already own a large stockpot, you can start for the price of a bag, a thermometer and ingredients — under €60. Skip the induction plate, use the hob you have, and accept that a 10-litre batch on a domestic ring will take a while to reach a boil. It's how I started and it made me appreciate the induction plate enormously when I finally bought one.
Frequently asked questions from small-space brewers
How do I set up a home brewery in a small flat?
Choose one vessel that doubles as mash tun and kettle, size it to your hob rather than to your ambition, and store every accessory inside it. I set mine up on a single 60 cm countertop, with the fermenter in a wardrobe and bottles in a crate under the bed. The whole system broke down into a pot, a bag and a box in under five minutes.
What does a complete home brewing equipment list look like?
Kettle with lid, mesh bag, heat source, thermometer, fermenter with airlock, bottling bucket or tap, siphon, bottles, cleaner and sanitiser. That's the whole list — anything beyond it is optional. You do not need a refractometer, a pH meter or a fermentation chamber to make good beer in a flat, and buying them before your first batch is a way of delaying the first batch.
Is there a best home brewery setup?
The best one is the one you'll actually use twice a month. A €900 all-in-one system that lives in a cupboard because it's a hassle to set up produces less beer than a €60 pot you can have boiling in ten minutes. I'd rather brew mediocre beer frequently than perfect beer never — the frequency is what teaches you.
Can I brew all-grain on an induction hob?
Yes, with two conditions: the pot must be magnetic (test it with a fridge magnet before buying) and the hob needs enough power to hold a rolling boil on 12–16 litres. A 2000 W portable plate handled my batches comfortably. Built-in hobs vary a lot — a cheap one may struggle, and you'll find out on brew day, which is not when you want to find out.
Where to start
Measure your hob, measure the clearance to your extractor, and buy a pot that fits both. Then buy a bag, a thermometer and a crushed grain kit for a style you actually like drinking. Brew it once. Drink the result. Notice what annoyed you. Fix one thing per batch.
Eleven months of brewing in a 42 m² flat taught me that the constraint was never space. It was the assumption that brewing needs a dedicated room and a wall of stainless steel. Strip that assumption out and what's left is a pot, a bag, and four hours on a Sunday — and the beer that comes out of it is every bit as good as the beer from the setups with three burners.
The first batch you brew in that kitchen will probably be worse than you hoped. The fourth will be better than you expected. That's the whole hobby, and it fits on one shelf.